IBM 865741Y Handbook - Page 114
in Using the Configuration/Setup Utility Program
View all IBM 865741Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Installing Microprocessors 11. If your server comes with an air baffle, reinstall it. To reinstall the air baffle, follow the instructions in step 2 on page 92 in reverse order. 12. If you replace the microprocessor with one that has a different speed, you must change the switch settings on the system board. To locate the switches, see "System Board Illustration" on page 203. For information about the appropriate switch settings, see "Setting the Microprocessor Speed Switches" on page 209, or see the label inside the server cover. 13. Go to Table 13 on page 196 to update the microprocessor information; then, return here. 14. Since you installed a new microprocessor in your server, you must reconfigure your server. Follow the procedure described in "Using the Configuration/Setup Utility Program" on page 28. You might also need to make changes to your operating system. If your operating system does not support SMP, install one of the SMP operating systems that your server supports. See http://www.us.pc.ibm.com/server/ on the World Wide Web. If your operating system does support SMP, refer to your operating-system documentation. You might need to make changes so that the operating system recognizes the new microprocessor. 96 Netfinity 3500 User's Handbook