IBM HC10 Service Guide - Page 46
Removing, battery, Installing
UPC - 883436017671
View all IBM HC10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Removing the battery To remove the battery, complete the following steps. 1. Read the safety information that begins on page vii and "Installation guidelines" on page 13 2. If the blade workstation is installed in a BladeCenter unit, remove it (see "Removing the blade workstation from a BladeCenter unit" on page 16 for instructions). 3. Remove the blade workstation cover (see "Removing the blade workstation cover" on page 19 for instructions). 4. Locate the battery on the system board (see "System board connectors" on page 7 for instructions). 5. Use one finger to press the top of the battery clip away from the battery. The battery pops up when released. 6. Use your thumb and index finger to lift the battery from the socket. 7. Dispose of the battery as required by local ordinances or regulations. Note: See "Battery return program" on page 89 for more information. Installing the battery The following notes describe information that you must consider when you are replacing the battery in the blade workstation. v When you are replacing the battery, you must replace it with a lithium battery of the same type from the same manufacturer. v To order replacement batteries, call 1-800-426-7378 within the United States, and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call your IBM marketing representative or authorized reseller. v After you replace the battery, you must reconfigure the workstation and reset the system date and time. v To avoid possible danger, read and follow the following safety statement. 30 BladeCenter HC10 Type 7996: Problem Determination and Service Guide