IBM HC10 Service Guide - Page 60
Configuration/Setup
UPC - 883436017671
View all IBM HC10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 7996," on page 11 to determine which components are CRUs and which components are FRUs. v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician. Error code Description Action 161 Real-time clock battery failure 1. Reseat the battery. 2. Clear CMOS. See "System board jumpers and buttons" on page 7 for information about how to clear CMOS. 3. Replace the following components one at a time, in the order shown, restarting the blade workstation each time: a. Battery b. (Trained service technician only) System board assembly 162 Invalid configuration information or CMOS 1. Run the Configuration/Setup Utility program, RAM checksum failure. select Load Default Settings, and save the settings. 2. Reseat the battery. 3. Replace the following components one at a time, in the order shown, restarting the blade workstation each time: a. Battery b. (Trained service technician only) System board assembly 163 Time of day not set. 1. Run the Configuration/Setup Utility program, select Load Default Settings, make sure that the date and time are correct, and save the settings. 2. Reseat the battery. 3. Clear CMOS. See "System board jumpers and buttons" on page 7 for information about how to clear CMOS. 4. Replace the following components one at a time, in the order shown, restarting the blade workstation each time: a. Battery b. (Trained service technician only) System board assembly 44 BladeCenter HC10 Type 7996: Problem Determination and Service Guide