IBM HC10 Service Guide - Page 5
Contents - connector
![]() |
UPC - 883436017671
View all IBM HC10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Contents Safety vii Guidelines for trained service technicians viii Inspecting for unsafe conditions viii Guidelines for servicing electrical equipment viii Safety statements ix Chapter 1. Introduction 1 Related documentation 1 Notices and statements in this document 2 Features and specifications 3 Blade workstation controls and LEDs 4 Turning on the blade workstation 6 Turning off the blade workstation 6 System board layouts 7 System board connectors 7 System board jumpers and buttons 7 Chapter 2. Configuration information and instructions 9 Firmware updates 9 Using the Configuration/Setup Utility program 9 Configuring the Gigabit Ethernet controllers 9 Blade workstation Ethernet controller enumeration 10 Chapter 3. Parts listing, Type 7996 11 Chapter 4. Removing and replacing blade workstation components . . . . 13 Installation guidelines 13 System reliability guidelines 15 Handling static-sensitive devices 15 Returning a device or component 15 Removing the blade workstation from a BladeCenter unit 16 Installing the blade workstation in a BladeCenter unit 17 Removing and replacing Tier 1 CRUs 19 Removing the blade workstation cover 19 Installing the blade workstation cover 20 Removing the bezel assembly 21 Installing the bezel assembly 21 Removing a SATA storage drive 22 Installing a SATA storage drive 23 Removing a memory module 24 Installing a memory module 24 Removing a compression card 26 Installing a compression card 27 Removing a graphics card 28 Installing a graphics card 29 Removing the battery 30 Installing the battery 30 Removing and replacing FRUs 32 Removing a microprocessor and heat sink 32 Installing a microprocessor and heat sink 34 Removing the system board assembly 36 Installing the system board assembly 37 © Copyright IBM Corp. 2007 iii
![](/manual_guide/products/ibm-hc10-service-guide-55048c8/5.png)