IBM HC10 Service Guide - Page 64
action
![]() |
UPC - 883436017671
View all IBM HC10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 7996," on page 11 to determine which components are CRUs and which components are FRUs. v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician. Error code Description Action 1804 No more base memory. 1. Run the Configuration/Setup Utility program and make sure that base memory settings are correct. 2. Remove each I/O-expansion card one at a time, restarting the blade workstation each time, until the problem is isolated. 3. Replace the following components one at a time, in the order shown, restarting the blade workstation each time: a. Failed I/O-expansion card b. (Trained service technician only) System board assembly 1805 ROM checksum fails. 1. Run the Configuration/Setup Utility program and make sure that ROM resource settings are correct. 2. Remove each I/O-expansion card one at a time, restarting the blade workstation each time, until the problem is isolated. 3. Replace the following components one at a time, in the order shown, restarting the blade workstation each time: a. Failed I/O-expansion card b. (Trained service technician only) System board assembly 1806 PCI device failure. 1. Run the Configuration/Setup Utility program to verify device settings. 2. Remove each I/O-expansion card one at a time, restarting the blade workstation each time, until the problem is isolated. 3. Replace the following components one at a time, in the order shown, restarting the blade workstation each time: a. Failed I/O-expansion card b. (Trained service technician only) System board assembly 1807 Planar device is not responding or is disabled. 1. Run the Configuration/Setup Utility program to verify device settings. 2. Remove each I/O-expansion card one at a time, restarting the blade workstation each time, until the problem is isolated. 3. Replace the following components one at a time, in the order shown, restarting the blade workstation each time: a. Failed I/O-expansion card b. (Trained service technician only) System board assembly 48 BladeCenter HC10 Type 7996: Problem Determination and Service Guide
![](/manual_guide/products/ibm-hc10-service-guide-55048c8/64.png)