Konica Minolta Fujitsu fi-7160 Operation Guide - Page 124
Bushing, Shaft, Retaining clip, Pick roller
View all Konica Minolta Fujitsu fi-7160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Chapter 7 Replacing the Consumables 3 Lift up the bushing in direction 1 (about 5 mm), and slide the shaft in direction 2 to pull out the leading end from the slot, then lift the shaft in direction 3 to remove it. 3 2 Bushing 1 Shaft ATTENTION Be careful not to touch the gear near the bushing on the shaft as it contains grease. 5 Remove the two pick rollers from the shaft one at a time. 1 Pull out the pick roller from the shaft as you lift the retaining clip. Retaining clip Shaft Pick roller TOP Contents Index Introduction Scanner Overview How to Load Documents 2 Pull out the other pick roller from the shaft as you lift the retaining clip. Configuring the Scan Settings Retaining clip Shaft Pick roller How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 124