Konica Minolta Fujitsu fi-7160 Operation Guide - Page 125
Shaft, Retaining clip, Pick roller, Bushing
View all Konica Minolta Fujitsu fi-7160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Chapter 7 Replacing the Consumables 6 Attach the two new pick rollers on the shaft on at a time. 1 Insert the retaining clip of the pick roller into the slot. Pick roller Retaining clip Shaft Slot 2 Insert the retaining clip of the other pick roller into the slot. Pick roller Retaining clip Shaft Slot ATTENTION Confirm that the pick roller is installed properly. Otherwise, it may cause feeding errors such as paper jams. Make sure to insert the pick roller until it locks in place. 7 Attach the shaft. 1 Insert the left end of the shaft into the slot, and lower the other end gradually. TOP Contents Index Introduction Scanner Overview 2 Rotate the bushing to lock the shaft. Shaft How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Bushing Shaft Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 125