Konica Minolta Fujitsu fi-7160 Operation Guide - Page 210

Appendix Item Specification fi-7160 fi-7260 fi-7180 Output resolution Binary (black & white) 50 to 600 dpi, 1200 dpi Grayscale Color Grayscale level 8-bit for each color Interface LCD USB3.0/2.0/1.1 (*8) Display: FSTN (black & white) Displayed dots: 110 × 65 Displayed lines: 16 × 5 (character × row) fi-7280 Notes 50 to 600 dpi: configurable in 1 dpi increments 1200 dpi: created by scanner driver 16-bit during internal processing Type B - *1: The minimum scanning area only applies to using the ADF. There is no limitation when using the flatbed. *2: Long page scanning supports documents with a length of up to 5,588 mm (220 in.) when the scanning resolution is set to 200 dpi or less. *3: When scanning plastic cards from the ADF, you can load up to 3 cards in the ADF paper chute (feeder). *4: Up to 1.25 mm is supported for scanning at 300 dpi or less (80 ppm) in landscape when using the fi-7180/fi-7280. This setting can be changed in the Software Operation Panel to scan plastic cards with a thickness up to 1.4 mm. For details, refer to " Scanning Thick Plastic Cards [Feed Mode] (fi-7180/fi-7280)" (page 195). *5: The paper weight only applies to using the ADF. There is no limitation when using the flatbed. *6: Note that this is the hardware limitation, and the software's processing time such as data transfer time is added to the actual time of scanning. *7: The capacity varies depending on the paper weight. For details, refer to "2.3 Documents for Scanning (ADF)" (page 45). *8: Connection with USB 3.0/2.0 requires the USB port and the hub to support USB 3.0/2.0. Also note that the scanning speed slows down when using USB 1.1. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 210