Konica Minolta Fujitsu fi-7160 Operation Guide - Page 156

Chapter 8 Troubleshooting The Carrier Sheet is not fed smoothly. / Paper jams occur. Did you scan just the Carrier Sheet continuously? No Is the Carrier Sheet clean? Yes Did you start the scan after loading the Carrier Sheet in the ADF paper chute (feeder)? Yes Are the glass and rollers inside the ADF clean? Yes Are the consumables (*1) worn out? No Is there any foreign matter inside the ADF? No Feed about 50 sheets of PPC paper (recycled paper) before scanning with the Carrier Sheet. Yes The PPC paper can either be blank or printed. Perform one of the following.  Clean the Carrier Sheet. No For details, refer to "Chapter 6 Daily Care" (page 108).  Replace the Carrier Sheet. For information on purchasing the Carrier Sheet, refer to "Scanner Options" (page 215). Start the scan after loading the Carrier Sheet in the ADF paper chute (feeder). For details, refer to "Documents Larger than A4/Letter Size" (page 89) or No "Scanning Photographs and Clippings" (page 91). Perform cleaning. For details, refer to "Chapter 6 Daily Care" (page 108). No Check the consumable counters and replace them if necessary. For details, refer to "Chapter 7 Replacing the Consumables" (page 119). Yes Clean the ADF. If there is any foreign matter in the ADF, remove it. For details, refer to "Chapter 6 Daily Care" (page 108). Yes TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 156