Konica Minolta Fujitsu fi-7160 Operation Guide - Page 150
Paper protection is set off frequently
View all Konica Minolta Fujitsu fi-7160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Chapter 8 Troubleshooting Paper protection is set off frequently. Do the documents meet the requirements described in "Precautions" in "Conditions" (page 45)? Yes Is there any foreign matter inside the ADF? No Are the consumables (*1) installed correctly? Yes Are the consumables (*1) clean? Yes Are the consumables (*1) worn out? No Is the high altitude mode enabled in the Software Operation Panel? No Use documents that meet the requirements. For details, refer to "2.3 Documents for Scanning (ADF)" (page 45). No Clean the ADF. If there is any foreign matter in the ADF, remove it. For details, refer to "Chapter 6 Daily Care" (page 108). Yes Install the consumables (*1) correctly. For details, refer to "Chapter 7 Replacing the Consumables" (page 119). No Clean the consumables (*1). For details, refer to "Chapter 6 Daily Care" (page 108). No Check the consumable counters and replace them if necessary. For details, refer to "Chapter 7 Replacing the Consumables" (page 119). Yes Disable the high altitude mode in the Software Operation Panel when using the scanner in places lower than 2,000 m. Yes For details, refer to "Scanning at High Altitude [High Altitude Mode]" (page 195). TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 150