Konica Minolta Fujitsu fi-7160 Operation Guide - Page 172

Chapter 9 Operational Settings Item Count (page 179) Power saving (page 203) Offset Setting (page 184) Vertical magnification Adjustment (page 184) Description Parameter/Value Check the counters to determine when to replace the consumables and to perform cleaning. Also use it to reset the counter when you have replaced the consumables or performed cleaning. Total Page Count(ADF) / Total Page Count(FB) (*1)/ After cleaning/Brake Roller/Pick Roller Remaining Ink (when the imprinter is installed) Specify the waiting time before entering power saving mode. This setting can also be configured in the operator panel. Range: 5 to 235 min. (in increments of 5) Power off after a certain period of time: Select to set the scanner to turn the power off automatically if the scanner is left on for a certain period of time without being used. Specify the timeout period for the scanner to be automatically turned off. This setting can also be configured in the operator panel. [Power off after a certain period of time] check box 1 Hour/2 Hours/4 Hours/8 Hours (When the [Power off after a certain period of time] check box is selected) Adjust the position to start the scan on the selected scanning side(s). Unit: Flat bed (*1) / ADF(front) / ADF(back) Main/Sub: -2 to 2 mm (in increments of 0.5) Adjust the magnification level in feed direction for the selected Unit: Flat bed (*1) / ADF scanning method. Range: -3.1 to 3.1% (in increments of 0.1) Factory Default 0 (*2) 15 min. Selected 4 Hours Main/Sub: 0 mm 0% *1: Displayed when using the fi-7260 or fi-7280. *2: Displayed when the imprinter is installed. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 172