Konica Minolta Fujitsu fi-7160 Operation Guide - Page 17
Parts and Functions, fi-7160/fi-7180
View all Konica Minolta Fujitsu fi-7160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Chapter 1 Scanner Overview 1.2 Parts and Functions This section shows the names of the scanner parts. fi-7160/fi-7180 ■Front Side guides Guides the documents in width direction as they are fed into the scanner. ADF (Automatic Document Feeder) Pulls and feeds the documents one sheet at a time from the ADF paper chute (feeder). Open to replace consumables or clean the inside of the scanner. Stacker Stacks up the ejected documents. Stopper Lift up to adjust to the document length. Stacker extension 2 Slide out to adjust to the document length. Stacker extension 1 Slide out to adjust to the document length. TOP Contents Index Introduction Scanner Overview Chute extension 2 Pull out to adjust to the document length. Chute extension 1 Pull out to adjust to the document length. ADF paper chute (feeder) Holds the documents to be scanned. ADF release tab Pull this tab to open the ADF. Operator panel Consists of an LCD, buttons, and LED indicator. Can be used to operate the scanner or check the status. For details, refer to "Chapter 4 How to Use the Operator Panel" (page 61). Stacker stand Used to adjust the tilt of the stacker. How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 17