Konica Minolta Fujitsu fi-7160 Operation Guide - Page 139
The LCD and the [Power] button light switch OFF
View all Konica Minolta Fujitsu fi-7160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Chapter 8 Troubleshooting The LCD and the [Power] button light switch OFF. Has the scanner been left out of operation for a long time after being powered on? No Does the LCD and the [Power] button light remain off even if you turn the scanner off and then on again? The scanner has entered power saving mode or has been automatically turned off. If the scanner has entered power saving mode Yes The LCD turns off but the [Power] button light remains green. Resume from power saving mode by one of the following methods: - Load a document in the ADF paper chute (feeder) - Press any button on the operator panel Note that pressing the [Power] button for more than 2 seconds will turn the power off. - Perform scanning from an application If the scanner has been automatically turned off The LCD and the [Power] button light are off. Turn on the scanner. For details, refer to "1.3 Turning the Power ON/OFF" (page 25). The scanner is operating correctly. No Yes If the problem persists, check the items in "8.4 Before You Contact the Scanner Service Provider" (page 159) first, then contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 139