Konica Minolta Fujitsu fi-7160 Operation Guide - Page 188
Shortening the Scanning Intervals [Pre-Pick
View all Konica Minolta Fujitsu fi-7160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
Chapter 9 Operational Settings Shortening the Scanning Intervals [Pre-Pick] "Pre-pick" refers to feeding the document to the starting position for scanning before the next scan. Enabling [Pre-Pick] shortens the interval between scanning each document. 1 Start up the Software Operation Panel. For details, refer to "9.1 Starting Up the Software Operation Panel" (page 163). 2 From the listing on the left, select [Device Setting 2] [Pre-Pick]. 3 Select [Yes] or [No]. HINT If you cancel in the middle of scanning while pre-pick is enabled, you will have to remove the pre-picked document, then load the document again. This setting can also be configured in the scanner driver or the operator panel. Note that priority is given to the scanner driver setting. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 188