Kyocera 9530DN Operation Guide - Page 67
>TCP/IP, >>DHCP, >>BOOTP, >>IP Address, >>Subnet Mask, >>Gateway
View all Kyocera 9530DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Using the Operation Panel 7 The following example explains how to activate TCP/IP protocol to connect the >TCP/IP > printer in the network. You can select On Netware or AppleTalk in a similar manner. If TCP/IP is currently displays Off, select On using U or V. Press [OK] again. >TCP/IP ? Off >TCP/IP > On 8 Press Z. Each time U or V is pressed, the item changes as shown below. >>DHCP Off >>BOOTP Off >>IP Address 000.000.000.000 >>Subnet Mask 000.000.000.000 >>Gateway 000.000.000.000 9 Display the item to be set and press [OK]. For DHCP or BOOTP, a question mark (?) appears. For IP Address, Subnet Mask, and Gateway, the cursor (_) blinks. 10 For DHCP or BOOTP, select On or Off using U or V. For IP Address, Subnet Mask, and Gateway addresses, press U or V to change the number (000 to 255) where the cursor is blinking. You can use Z and Y to move the cursor right and left. 11 To obtain these addresses, consult your network administrator. ADVANCED OPERATION GUIDE 2-39