Lexmark T632 Service Manual - Page 102

4060-xxx Main drive service check Service tip: Excessive gear or main drive assembly noise is usually caused by a defective motor assembly or system board. Service tip: If there are equally spaced horizontal lines across the page, go to "Print quality- evenly spaced horizontal lines or marks" on page 2-80. Warning: Whenever the gearbox assembly is removed from the machine it must be handled very carefully. Do not allow any of the gears to come in contact with any metal or other hard surface to avoid gear damage. It is also very important not to let any dirt, paper, staples, or other material come intact with the grease in the gearbox assembly. FRU 1 Main drive assembly (excessive noise or vibration) 2 Main drive motor assembly (excessive noise, gears ratcheting and so on) 3 Main drive motor cable 4 Motor does not turn, no gear error code 936 or user message 201 Paper Jam displays. Action Remove the controller board and run a Diagnostic Print Test in the continuous mode. Check the main drive assembly for any excessive noise or vibration. Determine if the noise is in the main drive, toner cartridge, fuser, or main drive gearbox. Look for any loose or worn parts in the developer drive assembly, main drive gearbox, or fuser. Repair as necessary. A service error code 936 - Transport Motor may be displayed. Check the voltage at J24-6 on the system board. It measures approximately +5 V dc when the motor is not running and goes to 0 V dc when the motor is running. If incorrect, replace the system board. If this does not fix the problem, replace the main drive motor. Check the continuity of the main drive motor cable. If incorrect, replace the cable. Check the voltages at J24 on the system board. Pin Voltage Static J24-11 When main drive motor is running +24 V dc J24-8 +5 V dc 0 V dc J24-7 +5 V dc 0 V dc J24-6 +5 V dc +2.5 V dc J24-5 +5 V dc 0 V dc J24-4 J24-1 +5 V dc +5 V dc +5 V dc 0 V dc If the voltage is incorrect, replace the FRUs in the following order: • Main drive motor assembly • System board 2-68 Service Manual