Lexmark T632 Service Manual - Page 41

4060-xxx Base printer sub error codes First 6 bytes sub error code data (xx can be any value) Explanation 84 xx 00 x1 x2 84 xx 01 x1 84 xx 02 x1 84 xx 04 84 xx 05 84 00 06 84 00 07 84 xx 0B x1 x2 x3 This code indicates that the input sensor in the printer is still actuated from the first sheet and the second sheet is ready to arrive at the sensor. (x1=media size, x2=media source) • Check the printer input sensor and flag for correct operation. The flag should operate freely. • Check for debris in the area of the input sensor. • Check the area of the transfer plate and input to the fuser for anything that might cause the paper to remain over the input sensor. Video never started on the page. (x1=media size) The video signal never started within 2 inches after actuating the input sensor. Check input sensor and flag. This error is the most common type of paper jam. Possible causes are: (x1=media size) • Multi sheet feeding. • A tray size sensing problem. • The media feeding from the paper source is slipping or media is slipping in input to the printer. The input sensor was covered during POST by a piece of media still in the machine when it was turned on. • Clear the media from the printer. • Run the base sensor test (input sensor) from the diagnostic tests menu to test the input sensor and flag for correct operation. There was media at the input sensor too early. There was not enough time between printhead start and the printhead mirror motor to lock. Possible causes for this error are: • Paper might be pre-staged in the paper source tray. • Paper is picking too fast. • A defective input sensor. A paper jam has been declared by a smart device. Immediate stop homing not allowed. A paper jam has been declared by a smart device. Homing was allowed before the stop. The option tray pass thru sensor was never actuated by a piece of media. (x1=media size, x2=media source, and x3=paper source where paper jam was detected) • Run the sensor test for the option tray that is displaying the error code and check the pass thru sensor for that tray for correct operation. • Check for paper picking from the selected paper input source. • If the error is being detected from a lower paper source, see if paper is feeding correctly from a paper source above the detected source. 84 xx 0f x1 x2 x3 84 00 10 The option tray pass thru sensor was never deactivated. (x1=media size, x2=media source, and x3=media source where paper jam was detected) • Check the pass thru sensor and flag for correct operation. • Check to see if paper has cleared the pass thru area of the option where the paper jam occurred. The main motor ID failed to identify either motor after two tries. Possible causes for this error are: • The main drive motor has stalled. • An incorrect main drive motor/gearbox assembly has been installed. Diagnostic information 2-7