Lexmark T632 Service Manual - Page 152

4060-xxx Paper jams-options Error Message 23x Paper Jam - Check Duplex Option Stage 2 Location 231 Paper Jam Input Sensor 232 Paper Jam Stage 1 Location 235 Paper Jam 236 Paper Jam 237 Paper Jam 234 Paper Jam 235 Paper Jam Exit Sensor Doublefeed Sensor 233 Paper Jam The paper is most likely jammed in the duplex option, however the paper can also be jammed in the redrive at the input to the duplex option. The redrive assembly may not be correctly installed or locked in position or the duplex link is bent and not aligned properly to allow paper to feed correctly into the duplex option. Use the specific errors below: • 231 Duplex Paper Jam - Rear-A piece of media did not arrive at the duplex input sensor, but did leave the printer exit sensor. • 232 Duplex Paper Jam - Rear-A piece of media did not clear the duplex input sensor but did leave the printer exit sensor. • 233 Duplex Paper Jam - Rear-A piece of media failed to make the duplex doublefeed sensor during turnaround. • 234 Duplex Paper Jam - Rear-The media did not reach the duplex exit sensor. • 235 Duplex Paper Jam - Front-A piece of media is over the duplex doublefeed sensor. • 236 Duplex Paper Jam - Front-A piece of media did not leave the duplex exit sensor. • 237 Duplex Paper Jam - Front-A piece of media did not reach the printer input sensor. • 238 Duplex Paper Jam-A piece of media is over one of the duplex sensors during a reset. • 239 Duplex Paper Jam-A paper jam has occurred in the duplex option. Note: When the StapleSmart finisher is installed, a secondary message may be displayed which advises whether or not to remove the job from the finisher. If a job has accumulated in the finisher, then the printer alternately flashes the primary and secondary messages to indicate that all accumulated sheets should not be removed during the jam clearance procedure. If the sheets are removed, then the printer does not reprint these sheets. 3-24 Service Manual