Lexmark T632 Service Manual - Page 204
Operator panel cable removal, Left door removal on Upper front cover removal
View all Lexmark T632 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
4060-xxx Operator panel cable removal Note: Pay careful attention to the cable routing through the printer before you remove the operator panel cable. 1. Remove the left cover. See "Left door removal" on page 4-9. 2. Remove the upper front cover. See "Upper front cover removal" on page 4-12. 3. Remove the outer system board shield. See "Outer shield removal" on page 4-52. 4. Disconnect the operator panel cable from connector J15 on the system board. 5. Remove the operator panel. See "Operator panel assembly removal" on page 4-48. 6. Remove the cable retainer from the left side of the upper front cover hinge assembly. Note the routing of the operator panel and cover closed switch cables. 7. Remove the old cable from the printer. 8. Plug the new operator panel cable into the operator panel. 9. Snap the operator panel into the upper front cover. 4-50 Service Manual