Lexmark T632 Service Manual - Page 36

4060-xxx Messages and error codes Service error codes Service error codes are generally non-recoverable except in an intermittent condition when you can POR the printer to temporarily recover from the error condition. Service error code Error code Action 900 RIP Software Go to "900 Error Code service check" on page 2-41. 901 Engine Flash Indicates that the flash which the system board code is programmed into is bad. Replace the system board. 902 General Engine Software Error These errors indicate an unrecoverable system software error. Replace the system board. 903 Paperport Link Driver Error 904 Interface Violation by RIP 905 Interface Violation by Paperport Device 906 RIP Interface Driver Error 910 DC Pick Motor DC Error Codes 910, 911, 912, 913, and 914 are indications that a Tray 1 paper feed Pick Motor Stall problem has been detected. Go to "Input tray(s) service check" on page 2-64. 911 DC Pick Motor Excessive PWM 912 DC Pick Motor below speed 913 DC Pick Motor over speed 914 DC Pick Motor: No encoder feedback Check the integrated paper tray (Tray 1) for correct paper loading. Reload the paper and POR the printer. If the error continues, go to "Input tray(s) service check" on page 2-64. 917 Transfer Roll Indicates a problem in the transfer roll area. Go to "Transfer roll service check" on page 2-94. 920 Fuser Error Indicates that the fuser is below temperature when printing. Go to "Fuser service checks" on page 2-52. 921 Fuser Error Indicates that the fuser is below standby temperature when the printer is idle. Go to "Fuser service checks" on page 2-52. 922 Fuser Error Fuser failed to reach standby temperature. Go to "Fuser service checks" on page 2-52. 923 Fuser Error Fuser is too hot during printing or when printer is idle. Go to "Fuser service checks" on page 2-52. 2-2 Service Manual