Magnavox MDR868H Owners Manual - Page 58
Others, Remote Control Code you Selected.
View all Magnavox MDR868H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Subtitle Recording Record to DVD with Closed Caption or not. 1 Select a desired item using [ K/ L ], then press [ OK ]. Record to DVD with Closed Caption. Old Off Record to DVD without Closed Caption. • Your setting will be activated. Others 1 Select a desired item using [ K/ L ], then press [ OK ]. Remote Control Code Select Sets the remote conntrol Code 1/2/3 for your Remote Control. By setting the Remote Control Code to this unit, you can prevent other devices from responding when you use the Remote Control. 1 Select your preferred Remote Control Code using [ K/ L ]. 2 Keep pressing [ OK ], then press the Remote Control Code you Selected. Code Select Code1 Code2 Code3 Sets the Remote Control Code to 1. Sets the Remote Control Code to 2. Sets the Remote Control Code to 3. 2 Set the Selected item in references below. Initial Setting Setting up the unit again. Refer to '3. INITIAL SETUP' on page 22. • Make sure that the Antenna Connection was completed. Code Alert Set whether you want to Display a message when the unit is receiving a different Remote Control Code. 1 Select a desired item using [ K/ L ], then press [ OK ]. Code Alert Old Off If this unit receives a different Remote Control Code, an error message will appear. If this unit receives a different Remote Control Code, any message will not appear. Standby Settings This unit boots up at a higher speed in "Normal Standby". activation, but Power Consumption in Standby mode will be increased. 1 Select a desired item using [ K/ L ], then press [ OK ]. Normal Standby In order to make the unit Start faster, then set to "Normal Standby", if done then this will increase the Power Consumption when the Power is Off in Standby mode. Energy Saving Standby "Energy Saving Standby" will reduce the Power Consumption during Standby rather than "Normal Standby". • Your setting will be activated. • If the unit and the Remote Control's Remote Control Code does not match, an error Display message will appear on the front panel:'rc 1' or 'rc 2' or 'rc 3'. If 'rc 1' is Displayed, you need to change the Remote Control's Remote Control Code by keeping press [ OK ] and press [ 1 ]. If 'rc 2', press [ OK ] and [ 2 ].If 'rc 3', press [ OK ] and [ 3 ]. Note(s) • You need to set both the unit and the Remote Control to the same Code. • The default setting for the Remote Control is "Code1". Note(s) • If you Select "Energy Saving Standby","fun-link(HDMI CEC)" is automatically set to "Off " and "Network Function" will be set automatically to "Do Not Use". EN - 58