Netgear FVS336G FVS336G Reference Manual - Page 98
Configuring the WAN Mode, Required for Dual WAN on WAN Mode
UPC - 606449052015
View all Netgear FVS336G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual Table 5-1. IP Addressing for VPNs in Dual WAN Port Systems Configuration and WAN IP address Rollover Modea VPN Gateway-to-Gateway Fixed Dynamic VPN Telecommuter Fixed (client-to-gateway through Dynamic a NAT router) FQDN required FQDN required FQDN required FQDN required a. All tunnels must be re-established after a rollover using the new WAN IP address. Load Balancing Mode Allowed (FQDN optional) FQDN required Allowed (FQDN optional) FQDN required Tip: When configuring VPN for a dual WAN port network, use the VPN Wizard to configure the basic parameters and then edit the VPN and IKE Policy menus for the specific VPN application, if necessary. Figure 5-1 shows the WAN Mode setup screen for Auto-Rollover Mode using WAN port 1 as the primary WAN port. The WAN mode configuration is described in "Configuring the WAN Mode (Required for Dual WAN)" on page 2-11. Figure 5-1 5-2 Virtual Private Networking Using IPsec v1.2, June 2008