TP-Link TL-WA7210N User Guide - Page 108

TL-WA7210N 2.4GHz 150Mbps Outdoor Wireless Access Point User Guide  Status - The status of this entry is either Enabled or Disabled.  Modify - To modify or delete an existing entry. To setup a virtual server entry, please take the following steps: 1. Click the Add New... in virtual servers page. (pop-up Figure 5-35) 2. Select the service you want to use from the Common Service Port list. If the Common Service Port list does not have the service that you want to use, type the number of the service port or service port range in the Service Port box. 3. Type the IP Address of the computer in the Server IP Address box. 4. Select the protocol used for this application. 5. Select the Enable option to enable the virtual server. 6. Click the Save button. Figure 5-35 Add or Modify a Virtual Server Entry  Common Service Port - Some common services already exist in the pull-down list.  Note: It is possible that you have a computer or server that has more than one type of available service. If so, select another service, and enter the same IP Address for that computer or server. To modify or delete an existing entry: 1. Click the Modify in the entry you want to modify. If you want to delete the entry, click the Delete. 2. Modify the information. 3. Click the Save button. Click the Enable All button to make all entries enabled Click the Disabled All button to make all entries disabled. Click the Delete All button to delete all entries. Click the Next button to go to the next page and Click the Previous button to return the previous page.  Note: If you set the virtual server of service port as 80, you must set the Web management port on System Tools → Remote Management page to be any value except 80 such as 8080. Or else there will be a conflict to disable the virtual server. 98