Toshiba Portege M400 PPM40C-TD30TEF Users Manual Canada; English - Page 104
Changing Ultra Slim Bay modules, Removing a module
View all Toshiba Portege M400 PPM40C-TD30TEF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Operating Basics Changing Ultra Slim Bay modules This section explains how to change modules in the Ultra Slim Bay. The illustrations show replacement of the optical media drive with the Ultra Slim Bay HDD adaptor. Therefore, the text refers to those modules. However, the procedures are the same for any of the modules: DVD-ROM&CD-R/ RW drive, DVD Super Multi drive and HDD adaptor. To avoid injury, do not put your hand into the Ultra Slim Bay slot. The TOSHIBA Mobile Extension is preinstalled to support hot swapping under Windows. Refer to Chapter 1, Introduction for information on using this utility to change modules while the computer's power is on. Removing a module Remove the as described below. 1. You can confirm that the disks are not operating with indicators. If all indicators are off, it means that no disks are operating currently. 2. Turn the computer upside down. Wait for all disk indicators to go out before you turn over the computer. Lay the computer down gently. Shock can damage the HDD or other components. 3. Remove the screw near the icon that holds the Ultra Slim Bay in place. 4. Make sure the screw in the Ultra Slim Bay lock screw is set in the hole to the unlock position. 5. Slide the Ultra Slim Bay latch to the unlock position. 4-22 User's Manual