Toshiba Portege M400 PPM40C-TD30TEF Users Manual Canada; English - Page 196
Installing the HDD Kit (Serial-ATA), With the connector connected
View all Toshiba Portege M400 PPM40C-TD30TEF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
Optional Devices 8. With the hard disk drive in a vertical position, lift it straight up and away from the connector. Connector Plastic tab Hard disk drive pack Figure 8-19 Removing the hard disk drive pack Installing the HDD Kit (Serial-ATA) To install the HDD Kit (Serial-ATA), follow the steps below. 1. Move the connector until it is vertical. 2. Hold the hard disk drive vertically with its label on the left. 3. Connect the hard disk drive to the connector. Ensure that the hard disk drive is connected to the connector in a vertical position. If the hard disk drive is slanted and connected to the connector, it might damage the connector. 4. With the connector connected, lower the hard disk drive down to the storage position. Connector Plastic tab Hard disk drive pack Figure 8-20 Installing the hard disk drive pack 5. Seat the cover and press down until the latches click into place. 6. Secure the cover with two screws. 7. Turn your computer over. 8-18 User's Manual