Yamaha M2500 Owner's Manual - Page 19
Stereo/monaural master,
View all Yamaha M2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Control panel Stereo/monaural master section This section controls the signals that are output from the rear panel ST OUT L/R and MONO/C OUT jacks (page 28). 1 MATRIX MATRIX 5 2 3 4 CHECK ON ON/EDIT CHECK ON ON/EDIT 6 10 5 0 5 10 20 30 40 50 60 AFL 10 5 0 5 10 20 30 40 50 60 AFL STEREO MONO/C 8 7 STEREO section A MATRIX switch If this switch is on ( ), the post-fader ST OUT L/R signal will be sent to the matrix (page 18). B ON/EDIT switch / ON, CHECK indicators The function of this switch and these indicators will change depending on the mode of the M2500. q In normal mode You can use the ON/EDIT switch to turn ST OUT L/ R on/off. When this is switched on/off, the ON indicator will be lit/dark to indicate the status. Channels that are switched off will not send any signals to the ST OUT L/R jacks or to the matrix. q In check mode When a scene (which contains the on/off state of the ON/EDIT switches) is selected, the on/off status memorized in that scene will be indicated by the lit/ dark status of the CHECK indicator. In check mode, you can also use the ON/EDIT switch to switch the CHECK indicator between lit/dark. (The current on/ off setting will not be affected.) For details on check mode, refer to page 32. C Fader This adjusts the ST OUT L/R output level. D AFL switch Using this switch, the signal sent to the ST OUT L/R jacks can be monitored from the MONITOR OUT/ PHONES jacks. If the PFL switches of all input channels are off, turning this AFL switch on (the indicator above the switch will light) will allow you to monitor the output signal of the STEREO section from the MONITOR OUT/PHONES jacks. Use the MASTER PFL switch of the monitor section to switch the monitor signal between pre/post-fader. MONO/C section E MATRIX switch If this switch is on ( ), the post-fader MONO/C signal will be sent to the matrix (page 18). F ON/EDIT switch / ON, CHECK indicators The function of this switch and these indicators will change depending on the mode of the M2500. q In normal mode You can use the ON/EDIT switch to turn MONO/C OUT on/off. When this is switched on/off, the ON indicator will be lit/dark to indicate the status. Channels that are switched off will not send any signals to the MONO/C jack or to the matrix. q In check mode When a scene (which contains the on/off state of the ON/EDIT switches) is selected, the on/off status memorized in that scene will be indicated by the lit/ dark status of the CHECK indicator. In check mode, you can also use the ON/EDIT switch to switch the CHECK indicator between lit/dark. (The current on/ off setting will not be affected.) For details on check mode, refer to page 32. G Fader This adjusts the output level of MONO/C. 16 M2500-Owner's Manual