Yamaha M2500 Owner's Manual - Page 29
Stereo input channel input, output jacks
View all Yamaha M2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Rear panel Stereo input channel input/ output jacks ST CH 4 ST CH 3 ST CH 2 ST CH 1 INPUT INPUT INPUT INPUT A L/MONO L/MONO L/MONO L 5 R R R R PHANTOM MASTER INPUT B OFF ON L R READ OWNER'S MANUAL DC POWER INPUT 3 4 C INPUT A jacks These are XLR-3-31 type input jacks (balanced) for stereo input channel 1. Nominal input level is +10 dB to -30 dB. In order to use these jacks, you must set the A/B select switch of stereo input channel 1 to the A position. The pin wiring is as follows. Male XLR plug 1 (ground) 3 (cold) 2 (hot) D INPUT B jacks These are RCA phono input jacks (unbalanced) for stereo input channel 1. Nominal input level is +10 dB to -20 dB. In order to use these jacks, you must set the A/B select switch of stereo input channel 1 to the B position. The pin wiring is as follows. RCA phono plug Tip (send) Sleeve (ground) E INPUT jacks These are TRS phone input jacks (balanced) for stereo input channels 2-4. Nominal input level is +10 dB to -30 dB. The pin wiring is as follows. Hot Cold Ground If you wish to input a monaural signal to stereo input channels 2-4, insert a plug only into the L/MONO jack. In this case, the signal that is input to the L/ MONO jack will be sent to both L and R of the stereo input channel. 26 M2500-Owner's Manual