ZyXEL Elite 2864 User Guide - Page 122
No action to poor signal quality.
View all ZyXEL Elite 2864 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
*M1 Leased-line auto-handshake on answer mode. *P0-15 Sets leased-line transmission power level, range from 0 dBm to -15 dBm (Default = -9 dBm); range from -12 dBm to -27 dBm if S35b3 is set. The maximum transmission power for Omni 288P and 288S is -9dBm and -3dBm, respectively. *Q0 No action to poor signal quality. *Q1 Retrain action taken if signal quality is poor. + *Q2 Adaptive rate; auto fall-back or fall-forward. (Default) *Q3 Disconnect for poor signal quality. *Rab Read remote profile b to local profile a: a= 0-3, local user profile number. b= 0-3, remote user profile number. 4, remote active configuration. 5, remote factory default. Note: The command *Rab only works when the modem is on-line, independent of the type of connection involved. + *S0 *S1 *T *V Note: Secondary channel disabled. (Default) Secondary channel enabled. Displays last caller ID message. Views password table. This command requires the supervisor password before execution. *Wab Writes the local configuration profile a to remote user profile b and resets the remote modem from that profile: a= 0-3, local user profile number. 4, local active configuration. 5, local factory default settings. b= 0-3, remote user profile number. Note: The command *Wab only works when the modem is on-line independent of the type of connection involved. 9-12