ZyXEL Elite 2864 User Guide - Page 169

Parameter Settings #L0 #L1 #L2 #C0 #C1 #C2 #C3 #C4 #C5 #C6 #C7 #P Sets maximum recording length: A4 (297mm ). Sets maximum recording length: B4 ( 364mm ). Sets maximum recording length: unlimited. Sets the minimum scan line time capability of the receiver: 20ms at 3.85 line/mm, T(7.7)=T(3.85). Sets the minimum scan line time capability of the receiver: 5ms at 3.85 line/mm, T(7.7)=T(3.85). Sets the minimum scan line time capability of the receiver: 10ms at 3.85 line/mm, T(7.7)=T(3.85). Sets the minimum scan line time capability of the receiver: 20ms at 3.85 line/mm, T(7.7)=1/2 T(3.85). Sets the minimum scan line time capability of the receiver: 40ms at 3.85 line/mm, T(7.7)=T(3.85). Sets the minimum scan line time capability of the receiver: 40ms at 3.85 line/mm, T(7.7)=1/2 T(3.85). Sets the minimum scan line time capability of the receiver: 10ms at 3.85 line/mm, T(7.7)=1/2 T(3.85). Sets the minimum scan line time capability of the receiver: 0ms at 3.85 line/mm, T(7.7)=T(3.85). Sets the local phone number; the phone number following the character 'P' can have up to 25 characters. The modem will exchange this phone number with the remote fax machine during the initial handshaking. Status Report Result Codes When the modem is set in the fax mode, each ATD or ATA command will make the modem try to establish a fax connection and the modem will send a status report result code back to the DTE (computer). NO DIAL TONE NO CARRIER BUSY NO ANSWER CONNECT FAX... Tries to dial, but no dial tone is detected. The handshake fails or no carrier is detected or time-out. The other party's phone line is busy. Expected quiet answer is not detected before time-out. See below. When a fax connection is successfully established, the modem returns this message: CONNECT FAX/SnnnnVnTnRnLnCnP 15-15