ZyXEL Elite 2864 User Guide - Page 158

Command +FBADMUL= Value 0-255 +FBOR=n n=0 n=1 +FBUF? +FCIG="string" +FCLASS=n +FCON +FCQ=n n=0 n=1 n=2 +FCR=n n=0 n=1 +FCTCRTY= 0-255 +FDCC=vr,br,wd,ln, df,ec,bf,st vr=0 vr=1 br=0 br=1 br=2 br=3 Description Error threshold multiplier: Determines if the "Copy Quality OK" on the T.30 flow chart is met. =0 to 255; a value of 0 implies that error checking is disabled. Phase C data bit order: Selects direct bit order. Selects reversed bit order in receiving mode for phase C data. Buffer size; a read only parameter: Allows the DTE to determine the characteristics of the DCE's buffer size. Local fax station ID string, for polling Rx. Service class selection: Refer to the +FCLASS Class1 command on page 15-2. DCE response: a fax connection is established. Copy quality check capability parameter: No copy quality check capability. Only checks 1D phase C data. Checks both 1D and 2D phase C data. "Capability to receive" parameter: The DCE will not receive message data or poll a remote device. The DCE receives message data or polls a remote device. ECM retry count; in Error Correction Mode only: The sender will try to send a partial page 4 times. =0 to 255; units of 4 retries. If the Continue To Correct (CTC) count is 0, it will not make any further attempts. DCE capabilities parameters. Vertical resolution: Normal; 98 lpi. Vertical resolution: Fine; 196 lpi. Bit rate: 2400 bit/s; V.27ter. Bit rate: 4800 bit/s; V.27ter. Bit rate: 7200 bit/s; V.29 or V.17. Bit rate: 9600 bit/s; V.29 or V.17. 15-4