ZyXEL Elite 2864 User Guide - Page 132
Setting up a ZyXEL Modem with the AS-400
View all ZyXEL Elite 2864 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Setting up a ZyXEL Modem with the AS-400 This is a typical application where the user will use both the synchronous feature of the modem and the V.25bis option. Although we are using the IBM AS-400 computer as an example, other mid-range systems and mainframes should be able to use the same strings. Please note that some systems may require other settings depending on the nature of the system or the application that you are running. You can consult our Technical Support Department if help is needed. You can set up a ZyXEL modem either from the front panel or by using AT commands, depending on whether you have an LCD-model or not. The AT commands or settings that might be related to this setup are: Link Speed Data Format Command Set DTR Option RTS Option DCD Option DSR Option Sync Clock Line Type Multi-Auto SYNC for AS-400 in most cases; AT&M3 V.25bis; AT*I1 108.2, Data Terminal Ready; AT&D2 CTS tracks RTS; AT&R0 Tracks Carrier; AT&C1 CCITT (ITU-T), modem control; AT&S1 Internal; AT&X0 Dial-up line; AT&Ln Most of the settings are already stored in Profile 2. All you need to change after the reset from Profile 2 is the COMMAND SET. The changes can be made either by selection from the front panel menu or by issuing AT commands from an asynchronous terminal. Setting from the LCD front panel 1) Press the up arrow MENU key from the idle screen then the down arrow ENTER key and you should see TERMINAL OPTIONS. 2) Press the right arrow key until the screen reads RESET = FACTORY DEFAULT. Press the ENTER key (down arrow key) here and use the right arrow key to pick PROFILE 2, then press the ENTER key again. The modem will display SYSTEM RESETTING and you will then see the idle screen of the new setup. Now press the MENU key (up arrow key), followed by the ENTER key. TERMINAL OPTIONS should appear. Press the ENTER key, then press the right arrow key until you reach COMMAND SET. 3) Press ENTER, then the right arrow key until V.25bis should appear in the display. Press ENTER to select it. 11-4