ZyXEL Elite 2864 User Guide - Page 163

+FCC=vr,br,wd,ln, df,ec,bf,st +FCLASS=n +FCO +FCQ=, +FCR=n +FCT=n +FDR +FDT +FEA=n +FIE=n +FIP rq=0 rq=1 rq=2 tq=0 tq=1 tq=2 n=0 n=1 0-255 n=0 n=1 n=0 n=1 DCE capability parameter: refer to the +FDCC Class 2 command on page 15-4 for parameter settings. Service class selection: refer to the +FCLASS Class 1 command on page 15-2. DCE response: fax connection is made. Copy quality check capability parameter: DCE Receive Copy Quality Checking is disabled. DCE Receive Copy Quality Checking is enabled. DCE Receive Copy Quality Correction is enabled. DCE Transmit Copy Quality Checking is disabled. DCE Transmit Copy Quality Checking is enabled. DCE Transmit Copy Quality Correction is enabled. "Capability to receive" parameter: The DCE will not receive message data or poll a remote device. The DCE receives message data or polls a remote device. DTE phase C time-out parameter. n=0-255, 1s units. Receive phase C data command: initiates document reception. Transmit phase C data command: releases the DCE to proceed with the negotiation. Phase C received EOL alignment parameter: Determines that T.4 EOL patterns are bit aligned (as received). Determines that the last received bits of T.4 EOL patterns are byte aligned by the DCE, with necessary zero fill bits inserted. Procedure interrupt parameter: Procedure interrupt requests from the remote station are ignored, and are not reported to the DTE. Procedure interrupt requests from the remote station are accepted, negotiated and reported using the +FVO response. Initializes facsimile parameters to factory default. 15-9