ZyXEL Elite 2864 User Guide - Page 141

Local profile modification is done by loading this profile as the active settings and then modifying and saving the active settings back to the profile. Then the connection is reestablished and the profile is transmitted to the remote modem. Reading a remote profile b into a local profile a is done by the command: AT*Rab whereby a=0-3 b=0-3 b=4 b=5 Local user profile number. Remote user profile number. Remote active configuration. Remote factory default. Return the modems to on-line status again. The local modem can upload (write) its profile to the remote modem's profile and have the remote modem reset from the new profile. This is done with the command: AT*Wab whereby a=0-3 a=4 a=5 b=0-3 Local user profile number. Local active configuration. Local factory default. Remote user profile number. The remote profile read and write commands - *Rab and *Wab - only work in the on-line condition. The connection speed and mode do not matter. The remote modem must be set to accept remote configuration by executing the AT*F1 command. The AT*F0 command will set the modem up to deny remote configuration requests. Because the modem uses the remote digital loopback mode to request remote configuration information, the remote digital loopback request must also be granted (AT&T4) on the remote modem to accept the remote configuration request. Remote configuration can also be activated from an LCD (also includes rackmount) model's LCD panel. The remote modem is set to grant remote configuration by setting bit 0 of S-register S36. For the local modem, set S36b1 to 1 for the read operation or to 0 for the write operation. Set S37b0-3 to the remote profile number and bits 4-7 to the local profile number. After the S-register settings are done, activate the remote configuration operation by going to the DIAGNOSTIC menu and activating the REMOTE CONFIGURATION submenu. Batch mode remote configuration is a convenient feature allowing you to preconfigure a remote modem in one of the local modem's user profiles and send it to the re- 13-3