Compaq AP500 Reference Guide - Page 103
Solving Network Problems
UPC - 743172574732
View all Compaq AP500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Solving Network Problems Continued Problem Possible Cause Diagnostics reports a failure. Possible resource conflict with another expansion board. The cable is not securely connected. The cable is attached to the incorrect connector. There is a problem with the cable or a device at the other end of the cable. The network controller is defective. Network controller interrupt overlaps the interrupt of an expansion board. 11-11 Possible Solution Factory default is 300h to 30Fh for Ethernet. Either remove and reconfigure the conflicting expansion board, or reconfigure the network controller. If the address is changed, ensure that the drive parameters match the new I/O address for the network controller. Ensure that the cable is securely attached to the network connector and that the other end of the cable is securely attached to the correct device. Ensure that the cable is attached to the correct connector. Ensure that the cable and device at the other end are operating correctly. Contact your Compaq authorized service provider. Run the Setup utility and modify the network controller memory value. Continued Compaq Professional Workstation AP500 Reference Guide