Compaq AP500 Reference Guide - Page 30

2-4 Compaq Setup and Diagnostic Software Computer Setup Features Continued Task View information regarding IDE devices connected to the system NOTE: ATAPI devices (CD-ROM, tape) are listed as ATAPI devices. Set the hard drive to Ultra-DMA (Ultra-ATA), EDMA, or PIO mode operation Enable/disable IDE drive translation Specify the boot order of installed peripheral devices (such as LS-120 drive, diskette drive, hard drive, or CD-ROM devices) Enable/disable serial and parallel port and/or set resources for onboard system devices (serial port, parallel port, etc.) Set the printer mode (flexible/standard) Set the Num Lock state at power-on Disable energy save mode Select timeout values NOTE: These selections appear only when energy save mode is set (default). Enable/disable power LED blink in suspend mode NOTE: This selection does not appear if the energy saver mode is disabled. Computer Setup Selection Click Built-in Devices, then click Storage. The information is displayed under IDE Devices. Click Built-in Devices, then click Storage. Under IDE Devices, select the appropriate Drive Timing. Click Built-in Devices, then click Storage. Under IDE Devices, select IDE Drive Translation. Click Built-in Devices, then click Storage. Click Boot Order. Click Built-in Devices, then click Communications. Select the appropriate options under Serial Ports or Parallel Port. Click Built-in Devices, then click Communications. Under Parallel Port, select the appropriate Bi-directional Port. Click Built-in Devices, then click Input Devices. Under Keyboard, turn on Num Lock State At Power-on. Click Built-in Devices, then click Power Management. Select Energy Save Disabled. Click Built-in Devices, then click Power Management. Under Hard Drive and/or Monitor, select the Timeout value. Click Built-in Devices, then click Power Management. Select Blink LED during Energy Save. Continued