Compaq AP500 Reference Guide - Page 79
Installing a Hard Drive in the Removable Hard, Drive Cage Bays 1 - 3
UPC - 743172574732
View all Compaq AP500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
8-9 Installing a Hard Drive in the Removable Hard Drive Cage (Bays 1 - 3) The removable hard drive cage is capable of being configured with up to three 1.0-inch hard drives or with two 1.6-inch hard drives. Other than using different screw holes, the installation for both drives is basically the same. To install a 1.0-inch hard drive in the removable hard drive cage: NOTE: Prior to installing a SCSI device, please read "SCSI Cables and Guidelines" later in this chapter. 1. Turn off the workstation and disconnect the power cord from the grounded AC outlet and the back of the workstation. 2. Remove the side access panel and the removable hard drive cage. 3. Remove four screws (top group of screws) from the air plenum located at the front of the workstation. 4. Refer to the following illustrations to install an optional hard drive. Figure 8-9. Installing a 1.0-inch hard drive in bay 2 Compaq Professional Workstation AP500 Reference Guide