Compaq AP500 Reference Guide - Page 14
Standard Features, Table 1-1 - professional workstation
UPC - 743172574732
View all Compaq AP500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
1-2 Product Features Standard Features The Compaq Professional Workstation AP500 offers the following standard features. Features may vary depending on your model. For a complete listing of the hardware and software installed in your workstation run the INSPECT utility in Chapter 2. Feature Processors Number of Processors L2 Cache Size Memory Optional Memory Upgrades Memory Controller Error Checking and Correcting (ECC) Memory Graphics Controller Expansion Slots Drive Controller Table 1-1 Standard Features Compaq Professional Workstation AP500 Standard with one 400-MHz or 450-MHz Intel Pentium II processor One processor, upgradable to two 512 KB 64-MB or 128-MB, 100-MHz Registered SDRAM DIMMs (upgradable to 1 GB). Supports 100-MHz ECC 32-MB, 64-MB, 128-MB, or 256-MB Registered SDRAM DIMMs. 800MB/s single channel memory controller Uses an encoding scheme for memory error detection and correction. (Specifically, this feature detects and corrects all single-bit memory errors, and detects and reports double-bit errors.) Ships with 2D/3D or 3D graphics controller. Refer to the appropriate guide on the SmartStart for Workstations CD under X:\DOCS\GRAPHICS, where X is your CD-ROM drive designation. Six slots with five open. Three dedicated PCI slots. One shared PCI/ISA slot (1 full-length PCI/ISA). One dedicated short ISA slot. One Accelerated Graphics Port (AGP) slot located on system board. Integrated IDE controller and Integrated Wide-Ultra SCSI controller on PCI local bus. Continued