Dell 2355DN User Guide - Page 178
Setup, Machine Setup, Reports, Network Settings, Network Setup, Ethernet Speed, TCP/IP IPv4, EtheTalk
View all Dell 2355DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
Item Requirements Network Protocols TCP/IPv4, IPv6 (DHCP, DNS, 9100, LPR, SNMP, HTTP, IPSec), EtherTalk, Novell NetWare NDPS services via TCP/IP & IPP on 5.x, 6.x, DHCP, BOOTP, SLP, SSDP, Bonjour (Rendezvous), DDNS, WINS, TCP (Port 2000), LPR (Port 515), Raw (Port 9100), SNMPv1/2/3, HTTP, Telnet, SMTP (E-mail Notification) Dynamic Addressing Server DHCP, BOOTP Printing a Network Configuration Page The Network Configuration page shows how the network interface card on your printer is configured. The default settings are suitable for most applications. 1 Press Setup Machine Setup from the home screen. 2 Press the Next ( ) button. 3 Press the up/down arrows to select Reports. 4 Press the up/down arrows to select Network Settings. The Network Configuration page prints out. Setting Network Protocols When you first install and power up the printer, all supported network protocols are enabled. If a network protocol is enabled, the printer may actively transmit on the network even when the protocol is not in use. This may slightly increase network traffic. To eliminate unnecessary traffic, you may disable unused protocols. 1 Press Setup Machine Setup from the home screen. 2 Press the Next ( ) button. 3 Press the up/down arrows to select Network Setup. 4 Press the up/down arrows until you see the desired protocol 5 If you selected Ethernet Speed, select a network speed. If you selected TCP/IP (IPv4) or TCP/IP (IPv6), assign a TCP/IP address. For details, see "Configuring TCP/IP". If you selected EtheTalk. a Press Activate. b Press the left/right arrows to change the setting to On (enable) or Off (disable). NOTE: When you set EtheTalk, you must restart your machine to apply new settings. 6 Press the home icon ( ) to return to the Standby mode. 177