HP 2500 Service Manual - Page 103
Formatter, then pull the formatter out of the formatter cage.
View all HP 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Formatter 1 Remove the following cover and assemblies: • right-side cover (see page 93) • interface cover (see page 98) • Jetdirect card (see page 91) • formatter cage (see page 99) 2 Remove six screws (callout 1) from the metal plate on the back of the formatter cage, and then remove the metal plate. 3 Lift the front edge (callout 2) of the formatter board upward to clear the tab (callout 3), and then pull the formatter out of the formatter cage. 2 32 12 Figure 48. Removing the formatter (1 of 2) Reinstall note It is possible to reinstall the formatter in such a way that the EIO cage is on the incorrect side of the metal tab on the formatter cage. Make sure that the EIO cage is in the correct position before replacing the six screws in the metal plate. Correct Incorrect EN 5 Removal and replacement 101