HP 2500 Service Manual - Page 106
Dc controller, Removing the dc controller
View all HP 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Dc controller 1 Remove the following covers and assemblies: • right-side cover (see page 93) • interface cover (see page 98) • formatter cage (see page 99) 2 Unplug the flat flexible cable (callout 1). 3 Release the cables from two cable-holders (callout 2) 4 Unplug one cable connector (callout 3) by pressing and releasing the tab on the side of the connector. 5 Unplug two cable connectors (callout 4) by releasing a clip on each connector (see the detail in the lower-left corner of figure 51). 6 Unplug the remaining 24 cable connectors. 12 2 42 32 Figure 51. Removing the dc controller 104 Removal and replacement C9706-90926
104
Removal and replacement
C9706-90926
Dc controller
1
Remove the following covers and assemblies:
•
right-side cover (see page 93)
•
interface cover (see page 98)
•
formatter cage (see page 99)
2
Unplug the flat flexible cable (callout 1).
3
Release the cables from two cable-holders (callout 2)
4
Unplug one cable connector (callout 3) by pressing and releasing the tab on the side of the
connector.
5
Unplug two cable connectors (callout 4) by releasing a clip on each connector (see the detail
in the lower-left corner of figure 51).
6
Unplug the remaining 24 cable connectors.
Figure 51.
Removing the dc controller
2
2
3
2
2
2
4
1