HP 2500 Service Manual - Page 128
Removing the gear assembly 2 of 2, in shows the grounding spring attached to the chassis.
View all HP 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Note 7 Remove eight screws (callout 6) from the gear plate. 8 Rotate the gear assembly away from the printer, beginning with the front edge. A grounding spring (callout 7, hidden) should remain attached to the printer chassis. If it does not, then either reattach it to the chassis or place it with the gear assembly to prevent misplacing it. 72 62 Figure 74. Removing the gear assembly (2 of 2) Reinstall note A grounding wire at the lower-back corner of the gear assembly must be hooked around the chassis at reinstallation. Callout 2 in figure 75 on page 127 shows the grounding wire. Callout 3 in figure 75 shows the grounding spring attached to the chassis. Align the following parts with the printer chassis: gear assembly shaft grounding spring grounding wire 126 Removal and replacement C9706-90926