HP 2500 Service Manual - Page 125
The two springs should remain attached to two pegs inside the printer. If the springs are
View all HP 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
8 Disengage the left and right hinges from the tray 1 guide and then slide both of the hinges off of their keyed holes (callout 6) in the printer. 9 Use needle-nose pliers to unhook two springs (callout 7), one at each side of the tray 1 guide, and then remove the tray 1 guide. 62 72 Figure 71. Removing tray 1 (2 of 2) Reinstall note The two springs should remain attached to two pegs inside the printer. If the springs are not attached, use needle-nose pliers to reattach them before reinstalling the tray 1 guide. EN 5 Removal and replacement 123
EN
5 Removal and replacement
123
8
Disengage the left and right hinges from the tray 1 guide and then slide both of the hinges off
of their keyed holes (callout 6) in the printer.
9
Use needle-nose pliers to unhook two springs (callout 7), one at each side of the tray 1
guide, and then remove the tray 1 guide.
Figure 71.
Removing tray 1 (2 of 2)
Reinstall note
The two springs should remain attached to two pegs inside the printer. If the springs are not
attached, use needle-nose pliers to reattach them before reinstalling the tray 1 guide.
2
2
7
6