HP StorageWorks 4000s NAS 4000s and 9000s Administration Guide - Page 41
Adding and Configuring NICs in a Team, Network Teaming and Configuration, Properties, Teaming Controls
View all HP StorageWorks 4000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Basic Administrative Procedures and Setup Completion Adding and Configuring NICs in a Team Before a NIC is teamed, verify the following: ■ The NICs must be on the same network. ■ The NICs must be DHCP enabled and the DNS server address must be left blank. Note: The teaming utility becomes unstable if static IP addresses, subnets, and DNS addresses are set before teaming. ■ Duplex and speed settings must be set to use the default values. To team the NICs: 1. Open the HP Network Teaming utility. The Network Teaming and Configuration Properties dialog box is displayed. The type of NIC and the slot and port used is shown. Figure 16: HP Network Teaming Properties dialog box 2. Highlight the NICs to team. 3. Click the Team button. The Teaming Controls tab of the Properties dialog box is displayed. NAS 4000s and 9000s Administration Guide 41