HP Xw9400 HP xw9400 Workstation - Service and Technical Reference Guide - Page 101
CAUTION, The audio cable is only required for Linux-based systems.
View all HP Xw9400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
To replace an optical drive: 1. Lift the green drivelock release lever while sliding the optical drive into the bay. When the optical drive is partially inserted, release the drivelock release lever, and slide the drive completely into the bay until the drive is secured. CAUTION: Ensure that the optical drive is secure. Failure to do so can cause damage to the drive when moving the workstation. 2. Connect the power, data , and audio (if required) cables to the drive and workstation. NOTE: The audio cable is only required for Linux-based systems. 3. If you are installing more than one optical drive, route the cable as in the following image. Figure 5-37 Connecting IDE (left) or SATA (right) optical drive cable to system board ENWW Removing and replacing components 91