HP Xw9400 HP xw9400 Workstation - Service and Technical Reference Guide - Page 165

Table 6-13 Network problems (continued) Problem Cause Solution Cannot connect to network server when attempting Remote System Installation. The network controller is not configured properly. Verify Network Connectivity, that a DHCP Server is present, and that the Remote System Installation Server contains the NIC drivers for your NIC. System setup utility reports unprogrammed EEPROM. Unprogrammed EEPROM. Flash the ROM. Solving memory problems CAUTION: For those systems that support ECC memory, HP does not support mixing ECC and nonECC memory. Otherwise, the system will not boot the operating system. Table 6-14 Memory problems Problem Cause Solution System will not boot or does Memory module is not not function properly after the correct type or installing additional memory speed, or the new modules. memory module is not seated properly. Out of memory error. Memory configuration might not be set up correctly. You have run out of memory to run the application. Memory count during POST The memory modules is wrong. might not be installed correctly. Insufficient memory error during operation. Too many Terminate and Stay Resident programs (TSRs) are installed. You have run out of memory for the application. Replace module with the correct industrystandard device for the workstation. Use the Device Manager to check memory configuration. Check the application documentation to determine the memory requirements, or add more memory. Check that the memory modules have been installed correctly and that proper modules are used. Delete any TSRs that you do not need. Check the memory requirements for the application or add more memory to the workstation. ENWW Troubleshooting scenarios and solutions 155