HP Xw9400 HP xw9400 Workstation - Service and Technical Reference Guide - Page 98
Battery, CAUTION,
View all HP Xw9400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Battery CAUTION: Before removing the battery, be sure your CMOS settings are backed up because all CMOS settings are lost when the battery is removed. To back up the CMOS settings, use Computer Setup and run the Save to Diskette option from the File menu. To remove the battery: 1. Disconnect power from the system (Pre-disassembly procedures on page 55), and remove the access panel (Access panel on page 63). Place the workstation on its side with the system board facing up. 2. On the system board, press on the release tab of the battery holder. 3. Rotate the battery enough to get beyond the latch, and lift it straight up. Figure 5-33 Removing the battery To install the battery, slide the battery into the holder until it snaps into place. 88 Chapter 5 Removal and replacement procedures ENWW