HP Xw9400 HP xw9400 Workstation - Service and Technical Reference Guide - Page 68
Removing and replacing components
View all HP Xw9400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Removing and replacing components This section discusses the procedures necessary to remove and install various hardware components on your workstation. Before servicing or upgrading your workstation: 1. Review the safety precautions and the Service considerations on page 51, as well as the Safety and Regulatory Information. 2. Locate and clear a suitable work area. 3. Shut down the system and remove power from the unit. 4. Gather your tools. 5. Remove all security devices. 6. Service your unit. 7. Restore power to your unit. NOTE: Prior to removing and replacing a component, make sure you remove all installed components that obstruct or prevent the removal of the component. If you are unsure how to remove a particular component, please do one of the following: 1. Refer to the appropriate section in this chapter. 2. If the content you desire is not referenced in this chapter, see www.hp.com/support/ xw9400_manuals and look under "Setup and Install - General" for instructions. 3. See the manufacturer's web site for instructions for a third party (non-HP) component. 58 Chapter 5 Removal and replacement procedures ENWW