Konica Minolta Kodak Ngenuity 9090DB User Guide - Page 46

Cleaning the separator roller, Clean Feed Rollers

Get Konica Minolta Kodak Ngenuity 9090DB PDF manuals and user guides View all Konica Minolta Kodak Ngenuity 9090DB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Cleaning the separator roller 9. Pull the separator roller door forward and hold it in place while you remove the separator roller by lifting it off the cradle. 10. Using a cleaning wipe, scrub the separator roller tires in a side-toside motion. Rotate the roller to clean the entire surface. 11. Open and hold the separator roller door to reinstall the separator roller. Align the separator roller correctly with the slots. Align the flat end of the shaft with the slot in the cradle and gently seat the shaft, which should fall in place. Do not apply pressure to seat the shaft. 12. Gently release the separator roller door back in place. Verify that the separator roller is seated level. 13. Close the transport cover and reset the maintenance reminder by clicking on the Clean Feed Rollers hyperlink on the Maintenance monitor. 14. Click Yes on the dialog box to confirm the feed rollers have been cleaned. The reminder will be reset for the next required maintenance session. A-61662 April 2010 5-7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
A-61662
April 2010
5-7
Cleaning the separator roller
9.
Pull the separator roller door forward and hold it in place while you
remove the separator roller by lifting it off the cradle.
10. Using a cleaning wipe, scrub the separator roller tires in a side-to-
side motion. Rotate the roller to clean the entire surface.
11. Open and hold the separator roller door to reinstall the separator
roller. Align the separator roller correctly with the slots. Align the flat
end of the shaft with the slot in the cradle and gently seat the shaft,
which should fall in place. Do
not
apply pressure to seat the shaft
.
12. Gently release the separator roller door back in place. Verify that
the separator roller is seated level.
13. Close the transport cover and reset the maintenance reminder by
clicking on the
Clean Feed Rollers
hyperlink on the Maintenance
monitor.
14. Click
Yes
on the dialog box to confirm the feed rollers have been
cleaned. The reminder will be reset for the next required
maintenance session.