Konica Minolta Kodak Ngenuity 9090DB User Guide - Page 49

Cleaning the sensors, Feeder sensor, Gap sensor, entry sensors and pass thru sensor

Get Konica Minolta Kodak Ngenuity 9090DB PDF manuals and user guides View all Konica Minolta Kodak Ngenuity 9090DB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

Cleaning the sensors There are 7 sensors that require regular cleaning. Use only the supplied blower brush to clean these sensors. Do not use any type of cotton swab or cloth as these items may leave lint in the sensors. NOTE: If problems persist after cleaning the sensors, it may be necessary to use forced air to clean the sensors. If using forced air, use the extension tube on the can to spray the forced air. Do not turn the can upside down or tip it sideways. 10. Feeder sensor: Place the brush end of the blower brush into the feeder sensor area and squeeze the blower brush several times to clean the feeder sensor on the feeder table. Feeder sensor 11. Gap sensor, page entry sensors and pass thru sensor: Open the transport cover to clean these 5 sensors by placing the brush end of the blower brush into the each sensor area and squeeze the blower brush several times to clean. Top or front page tray assembly Gap sensor Page entry sensors (3) Pass thru sensor 5-10 A-61662 April 2010

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
5-10
A-61662
April 2010
Cleaning the sensors
There are 7 sensors that require regular cleaning. Use only the
supplied blower brush to clean these sensors. Do not use any type of
cotton swab or cloth as these items may leave lint in the sensors.
NOTE: If problems persist after cleaning the sensors, it may be
necessary to use forced air to clean the sensors. If using forced
air, use the extension tube on the can to spray the forced air. Do
not turn the can upside down or tip it sideways.
10.
Feeder sensor
: Place the brush end of the blower brush into the
feeder sensor area and squeeze the blower brush several times to
clean the feeder sensor on the feeder table.
11.
Gap sensor, page entry sensors and pass thru sensor:
Open
the transport cover to clean these 5 sensors by placing the brush
end of the blower brush into the each sensor area and squeeze the
blower brush several times to clean.
Feeder sensor
Top or front page tray assembly
Gap sensor
Page entry
sensors (3)
Pass thru
sensor