Konica Minolta bizhub PRESS C6000 IC-307 User Guide - Page 122

114 Parameter Option Marks Margins Gutter Spine Chapter 11-Job parameters Description Provides the following options: ● None-Does not apply any marks on the imposition layout for the printed job. ● Crop marks-Prints the lines that indicate where the sheet should be cropped to the trim size. Notes: ● If you want to use crop marks that were incorporated in the DTP application, make sure that enough space is left around your page in the PostScript file so that the page prints with crop marks. ● If your job already includes crop marks incorporated in the DTP application, you do not need to add crop marks here. If you do add crop marks, both sets of crop marks can be printed. ● Fold marks-Prints the lines that indicate where the sheet should be folded. This option is available only when the imposition method is set to Saddle stitch or Perfect bound. ● Crop & fold marks-Prints the lines that indicate where the sheet should be cropped and folded. This option is available only when the imposition method is set to Saddle stitch or Perfect bound. ● Both Sides-Prints the marks on both sides of the page. Determines the space between the edge of the pages and the edge of the sheet on which the pages are printed. Notes: ● Margin settings should suit the finishing equipment and requirements. ● Confirm the binding parameters with your binder when planning your sheet. Determines the space between pairs of pages (according to the trim size) on a sheet. When the pages are folded into a booklet, the gutter allows space for trimming. The value that you enter depends on the paper size and imposition method that you choose. Note: This option is available only when the imposition method is set to Perfect Bound. Determines where the signatures are joined at the center fold and then stitched or bound. The value that you enter depends on the paper size that you choose.